Set up guide for laser cutting and engraving?

Students are not permitted to use the laser cutter. Charges apply per minute for the laser beam used. What is a Laser? The ultimate way to explain what a laser does indeed is that it’s a printer.The preferred program to use the Laser cutter is – AutoCAD.Typical Set Out for AutoCAD designs. The pulling should be attracted to model size, NOT REAL SIZE. It should be saved as the DWG or a DXF

Setting up your laser work

It is not the responsibility of the providers of the laser cutter beam to fix laser beam data when work is published on the wrong size mattress sheets. All work attracted incorrectly will be going back to the student to solve. Once resubmitted, it’ll be positioned in the queue.

Usually, do not use tiers – Make certain all laser work is at layer

After drawing the model always ‘overkill’ your drawing. Overkill is an add-on in AutoCAD. It could only be filled when installing off the drive. See laser cutter in Technical Services (level 4) for more information. This add-on looks for double lines which can be a problem when it’s scanned into the lasers as the dual lines are recognized and can be in the thousands especially on scanned, hands drawings. When you have a green collection over a magenta brand the laser will engrave it as well as trim it. Always overkill before shade coding your pulling as it’ll change the color of some lines.

Sheet Sizes

DO NOT Utilize the outside ends of the sheet as a border as explained above, always allow an offset of 5mm minimum amount around all edges as shown in the example sheet below.


Please do not bring plastics to be lower as it transmits a harmful gas Students can source their own materials but also for convenience a few of the above-mentioned materials are for sale to purchase from the laser cutter workshop.

The workshop stocks and shares the next materials: MDF 3mm, 6mm, 9mm Strawboard 1mm, 2mm, 3mm White pasteboard 1mm, 2mm

The workshop securities these materials as the materials are in one provider and the wetness content is constant and the operator knows the options and test tests aren’t required. If offering your own, please offer an additional part (100mm x 200mm) to allow the operator to check cuts before chopping your model. 1mm straw motherboard is the most cost-effective material to build models.

Various ways of trimming and engraving

Below are the description and the colors needed to create the laser. They must be true colors. The most inexpensive way of using the Laser beam is by vector trimming and vector engraving using AutoCAD. Vectors are lines. Make an effort to use common lines where one brand makes two objects according to the example attracting sheet.

Hopefully, now you have your own laser lower (or etched) thing. Whether you made a decision to etch into clear Plexiglas to make an LED Sign, your computer so that it looks that a lot greater, or you’re preferably these guidelines where helpful. If on your voyage to etch and lower things with a laser cutter, you will find anything here baffling, or you think I’m lacking something important, please I want to know, and I’ll add it immediately!

Read more in this post:

Comments are closed.